How do I change the battery in the battery compartment?

To change the battery in the battery compartment: 1. Make sure the power is turned off. 2. Slide the battery compartment cover off. 3. Use a pointed object such as a ballpoint pen to set the battery selection switch inside the compartment to the appropriate position.

How to remove battery compartment?

To open the battery compartment of a Pentax Remote Control F, you need to remove the three small screws with a tiny phillips screw driver. Be careful not to lose the screws or damage the remote while putting in a new battery.

How do you replace a battery holder?

Insert a paper clip or pen point into small hole on left side of the cover. Push in on left side of cover while sliding it to the right. Remove battery holder. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries). Put battery hold back into safe.

How do I replace the battery drawer?

Pull out the battery drawer on side of electronic lock to the right. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries). Replace the battery drawer by sliding it to the left. Pull out the battery drawer.

How do I replace a 9v battery?

Carefully remove jumper wire and attach a 9V battery. If attached properly, you will get 3 chirps from electronic lock. Enter 5 digit code, and pull handle to open. Once opened, remove 9V, replace jumper in it's storage compartment, and replace Lithium Cells inside door per instructions.

How do I use a battery auxiliary override?

Remove battery compartment from inside door. Insert 2-batteries as indicated (Do not use rechargeable, or Non-CR123 Lithium batteries. Do not mix old with new batteries or mix brands of batteries). If battery is low and unable to operate open, use Battery Auxiliary Override. This should not be used as a primary means of gaining entry into safe.